![]() ![]() INFO detected 127.0.0.53 nameserver, assuming systemd-resolved, so using nf: /run/systemd/resolve/resolv. I got the following error message: "" INFO Starting up The following worked when running on an ubuntu:16. Main PID: 9805 (code=exited, status=1/FAILURE)Ībr 30 20:05:46 linux systemd: rvice: Service hold-off time over, sĪbr 30 20:05:46 linux systemd: rvice: Scheduled restart job, restarĪbr 30 20:05:46 linux systemd: Stopped Docker Application Container Engine.Ībr 30 20:05:46 linux systemd: rvice: Start request repeated too quĪbr 30 20:05:46 linux systemd: rvice: Failed with result 'exit-codeĪbr 30 20:05:46 linux systemd: Failed to start Docker Application ContainerĪfter searching more, I found I should restart Daemon, so I ran the following line: 3 Answers Sorted by: 8 After some investigation I was able to run a docker container with the ability to run systemctl command. Loaded: loaded (/lib/systemd/system/rvice disabled vendor preset:Īctive: failed (Result: exit-code) since Fri 20:05:46 -05 13min See system logs and ‘systemctl status rvice’ for details.”ĭrvice - Docker Application Container Engine ![]() (g-io-error-quark, 36)įailed to start rvice: Refusing activation, D-Bus is shutting down. “Error getting authority: Error initializing authority: Error calling StartServiceByName for 1: GDBus.Error:: Refusing activation, D-Bus is shutting down. Is he docker daemon running?.”Īfter used the following two commands I found on a blog: “The following error message appeared: docker: Cannot connect to the Docker daemon at unix:///var/run/docker.sock. “sudo docker run -it -rm -runtime nvidia -network host nvcr.io/nvidia/l4t-ml:r32.5.0-p圓” It got installed properly, and no problema was shown, however just after I rebooted and connected to the jeston via SSH, I tried running the container using: Sudo docker pull nvcr.io/nvidia/l4t-ml:r32.5.0-p圓 I tried to pull a docker using the following command: ![]() We have to do that manually, here is the command to start the Docker. Docker service will not be started and enabled by default after you complete its installation. I’ll describe the problem and all the error messages i’ve obtained while trying to implement the solutions: sudo dnf install docker Step 3: Start and Enable its Service. I’ve had this issue with the jeston for about a week now, I’ve been searching for solutions, but none seem to work or address directly my issue. I started using Linux a few months ago when I got a Jeton Nano for a Masters Course Project. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |